Nesting and Cutting Optimization Software

Fixed a bug which allowed previous optimizations to be re-run (from the Latest solutions menu) after the current solution is accepted. Now, the Latest solutions menu is disabled after Accept and is re-enabled after Undo.

Fixed a bug in Find optimal stock length procedure where the length of parts were not extracted before the search starts, thus no results were generated.

Show utilization percentage in the Find optimal stock length table because not all pieces are utilized if the minimal searched length is smaller than minimum piece length.

Fixed a bug which colored with gray the background of pieces cells when the bar height was small.

Fixed the position of waste text inside cell.

Add new options (in the Interface window) to set the number of digits after decimal separator for prices, wastes and percents.

Changed the window used to assign pictures to materials. From the new window the user can delete the picture assigned to a material. The old button for deleting picture (from the Materials window toolbar) has been removed.

Fixed a problem where some special characters (\ / : * ? ” < > |) in the material name prevented the image from being saved to disk. These special characters are now replaced by _ in the filename of the image assigned to a material. This solution is not perfect (since the same character replaces multiple invalid characters), but it is better than before … and will be improved in the near future.

Pieces are draw with real height when the angles are different from 90.

If the angles are 90, and heights are greater than 0, the user can force the drawing with fixed height from Results | Additional | Draw the pieces with a fixed height menu.

Fixed a bug where values for angles were not validated while manually entered in the Parts table. Valid values for angles are between 0 and 180 degrees.

Fixed a bug where UI settings were loaded from a project file when the project was imported. This behavior was not intended.